x-ray

The bench design for the x-ray model

This entry is part 6 of 20 in the series My X-Ray model project

So here we have the final part of the model draft design that helps to understand just what I will be creating in Blender. To be honest, I probably did not need to break it down to four components. The middle two could probably have been combined, but just looking at them I felt them to be separate components. I think the design speaks for itself.   So the next

C-arm broad design for 3D x-ray model

This entry is part 5 of 20 in the series My X-Ray model project

Hi all, Below is a diagram where I have deconstructed the various photos and videos of X-Ray machine C-arms into their various components in preparation for my Blender build. Obviously there is a lot of guesswork involved, but it is all I need to go forward with this design. As you will see I have identified six discrete objects. I pondered a bit over the Image Intensifier and it’s interface

3D x-ray model project - Phase2: Planning

This entry is part 3 of 20 in the series My X-Ray model project

Continuing with following a project methodology to create a model of an x-ray machine, I am working on the Planning phase. “The Planning Process Group consists of those processes performed to establish the total scope of the effort, define and refine objectives, and develop the course of action required to attain those objectives.” – A Guide to the Project Management Body of Knowledge (PMBOK Guide) Fifth Edition Design A generic x-ray